ID = 2998
SEQUENCE NUMBER = 2478521
TIME = 27-06-2011 20:43:15
LOCALIZED MESSAGE = Controller ID: 0 PD inserted: :32
ID = 2997
SEQUENCE NUMBER = 2478520
TIME = 27-06-2011 20:43:15
LOCALIZED MESSAGE = Controller ID: 0 Power supply removed on enclosure: 00:0 Power Supply 1
ID = 2996
SEQUENCE NUMBER = 2478519
TIME = 27-06-2011 20:43:15
LOCALIZED MESSAGE = Controller ID: 0 Communication restored on enclosure: 00:0
ID = 2995
SEQUENCE NUMBER = 2478518
TIME = 27-06-2011 20:43:14
LOCALIZED MESSAGE = Controller ID: 0 SES enclosure discovered: 00:0
ID = 2994
SEQUENCE NUMBER = 2478517
TIME = 27-06-2011 20:43:11
LOCALIZED MESSAGE = Controller ID: 0 Fatal firmware error: External Enclosure Pd 20 violation detected in Direct PD Mapping mode請問是什麽問題有辦法解決么?
C:\cli>megacli64 -directpdmapping -dsply -a0
Adapter 0: Direct Pd Mapping is: Disabled
Exit Code: 0x00
C:\cli>megacli64 -h -directpdmapping
MegaCLI SAS RAID Management Tool Ver 8.01.06 Dec 23, 2010
(c)Copyright 2010, LSI Corporation, All Rights Reserved.
DirectPdMapping
---------------
Syntax: MegaCli -DirectPdMapping -Enbl|-Dsbl|-Dsply -aN|-a0,1,2|-aALL
Description:
Command sets the mapping mode of physical drive.
The possible parameters are:
Enbl: Enables Direct physical drive mapping mode.
Dsbl: Disables Direct physical drive mapping mode.
Dsply: Displays current state of direct physical drive mapping.
Convention:
-aN N specifies the adapter number for the command.
-a0,1,2 Specifies the command is for adapters 0, 1, and 2. More than one adapter can be selected.
-aALL Specifies the command is for all adapters.
Exit Code: 0x00
Invalid input at or near token -directpdmapping ??請問下是我軟件下的不對? 作者: per1-q1222 时间: 2011-6-27 23:36
thenero 发表于 2011-6-27 23:30
回复 per1-q1222 的帖子
Invalid input at or near token -directpdmapping ??請問下是我軟件下的不對? ...
不是...
你要仔細看英文解釋...
這一看就知道你命令下的不對了... 作者: thenero 时间: 2011-6-27 23:46
奇怪了
CreateFile failed with error: 5
CreateFile failed with error: 5
CreateFile failed with error: 5
ERROR:Could not detect controller.
Failed to get ControllerId List.
Failed to get CpController object.