New LSI LSISAS2108 RoC MR firmware v12.14.0-0185...

per1-q1222 · 发表于 2014-2-16 22:31

本帖最后由 per1-q1222 于 2014-2-16 22:34 编辑

this firmware is from Intel....
and, many bug fixes....
enjoy it!...

http://downloadmirror.intel.com/23601/eng/ir3_2108SASHWR_FWPKG-v12.14.0-0185.zip

Package - 12.14.0-0185 (4.11 Patch)
Firmware 2.130.393-3027
  SCGCQ00426160 - MegaRAID iMR FW with "enableReducedFeatureSet=1" issue
  SCGCQ00475764 - after the newest image is installed, servers often will not boot.
  SCGCQ00475589 - FW sending wrong configuration data during boot msg pending state
  SCGCQ00466496 - Not able to change the properties of MSM.
  SCGCQ00463043 - Upgrading from Software RAID to 9260-8i causes Alarm to sound
  SCGCQ00455655 - Error in MR_DCMD_CTRL_EVENT_COUNT/SL_DIR_READ
  SCGCQ00454839 - MSM log warning: Controller booted in headless mode with errors
  SCGCQ00426916 - Data Corruption with R5 cachedIO mode
  SCGCQ00349837 - Sequential Read performance is less on CacheCade associated LD's.
  SCGCQ00467839 - Montask occurs when running host i/o and parallel OOB command
  SCGCQ00464657 - Generic point release MR4.9 :VPD output of lspci vvxxx showing [RV] Reserved: checksum bad, 86 byte(s) reserved
  SCGCQ00450935 - When pinned cache present VD property not changing from WB to WT.
  SCGCQ00440568 - 9260-8i(SAS2108) hitting OOB SRAT timeout for a long time causing OOB commands to fail
  SCGCQ00584561 - Check-in Pl version 5.0.42.0 -- Improve STP connection timing behavior with idle connections
  SCGCQ00558885 - Checking-in new PL version :05.00.41
  SCGCQ00488348 - To check-in new PL version 5.00.40.00
  SCGCQ00427464 - Discard preserved cache takes excessive time or hangs
  SCGCQ00458860 - Controller always gives an event MR_EVT_CTRL_BOOT_HEADLESS_MODE_HAD_ERRORS if controller is set in HSM mode.
  SCGCQ00457324 - Montask occurs when running host i/o and parallel OOB command
  SCGCQ00455014 - PDs go online without VD created & App doesn't allow any VD creation on passing a wrong parameter in Spanned VD.
  SCGCQ00456152 - To Disable the logging of event MR_EVT_PD_EMERGENCY_SPARE_COMMISSIONED_REMINDER
  SCGCQ00479336 - EEprom CRC error is detected when WebBIOS is running
  SCGCQ00491037 - STP Passthrough Support through OOB
  SCGCQ00471180 - FW is not declaring the battery bad if learn cycles fail continuously
  SCGCQ00467625 - Validate the requested blocks for SCSI VERIFY commands on RAID volumes
  SCGCQ00451971 - see 9261-8i emergency spare being commissioned
  SCGCQ00437904 - Data Miscompare found while running I/O overnight with degraded virtual drives
  SCGCQ00456777 - FW halts when you have pinned cahce and remove VD form the configuration.
  SCGCQ00458859 - FW halts when you have pinned cahce and remove VD form the configuration.
  SCGCQ00462516 - Card Running iMR Machine Checks when Requesting Host Memory
  SCGCQ00478812 - Minimum Capacity needed for relearn is incorrect in 2208 MR FW
  SCGCQ00558100 - Incorrect variable type in MR Read/Modify/Write path
  SCGCQ00558115 - RM_SataBBMTotalCount always return 0
  SCGCQ00558947 - FW Automatically detect backplane SGPIO type to set the driveactivityLED parameter
  SCGCQ00559344 - Setting the ASO key with storcli 1.02.08 (MegaCli 8.07.06) fails with an error code 3 on Windows or Linux if the MB BIOS PCI
  SCGCQ00451982 - Discard preserved cache takes excessive time or hangs
  SCGCQ00433403 - During rebuild on PRL11 CacheCade VD and rebuild on RAID6 Source VD IO integrity error is seen.
  SCGCQ00433391 - IO integrity error seen after Source VD associated with CacheCade VD is forcibly unblocked
  SCGCQ00579790 - LDBBM on RAID6 not eligible
  SCGCQ00458879 - PCIe core has received a PCIe request that it does not support
  SCGCQ00459017 - Firmware returns asc value as 0 when failing IOs with medium errors
  SCGCQ00475895 - Firmware hits Montask when drive is pulled after changing the volume property from read ahead to no read ahead.
  SCGCQ00476387 - Faulty protocol used for changing the Disk Write Cache Policy
  SCGCQ00487207 - BU SOH bad message be posted after exhauting retry attempts. Stop monitoring battery once SOH bad is declared
  SCGCQ00487654 - RHEL6.4 Kernel crash after reboot
  SCGCQ00488061 - Medium error correction event is not logged during CC
  SCGCQ00558908 - Firmware Version 2.130.383-2912 is hitting MonTask at line 1209 in file ../../raid/1078dma.c
  SCGCQ00449634 - Source VD gets blocked on OCR after one PD removal from R0 WB CCVD and reuse of that PD in creating another CCVD.
  SCGCQ00447651 - Data Corruption seen when IOs are in progress and cachecade PD is marked as missing and reused to create another SSC VD.
  SCGCQ00433563 - Sequential Read performance is less on CacheCade associated LD's.
  SCGCQ00433409 - When a Cachecade PD marked as missing is reused to make Cachecade VD IO integrity error is observed.
  SCGCQ00434393 - Saved Release Note DataSLIB returning bad data as good data after host reboots
  SCGCQ00458876 - (Vital Product Data) needs to identify PCB hardware level
  SCGCQ00476060 - Validate the requested blocks for SCSI VERIFY commands on RAID volumes
  SCGCQ00476108 - If a BOOT Passphrase is enabled with SafeStor "MegaCli adpbios dsply a0" will display "BIOS will Stop on error" even if any other mode is set.
  SCGCQ00488447 - Update the events
  SCGCQ00558950 - Firmware is not updating recovery timer as intended
  SCGCQ00484210 - "chip paused" causes high service time on all drives
  SCGCQ00450646 - 9260-8i(SAS2108) hitting OOB SRAT timeout for a long time causing OOB commands to fail
  SCGCQ00583755 - Raid configuration loss after reboot - PDs in POWERSAVE
  SCGCQ00487664 - Code Review: Call DDF_discardInvalidPds only if DS3 is enabled
  SCGCQ00558924 - Upgrading from Software RAID to 9260-8i causes Alarm to sound
  SCGCQ00479291 - system black screen during S1 Sleep test
Medusa_Expander SAS2XFW-25.05.04.00_MFGIMG-25.05.04.00
NVDATA 2.09.03-0046
  OEM specific change only
BootBlockCommon 09.250.01.219
BootBlock 2.02.00.00-0000
ROMENV 1.08
WebBIOS 6.0-52-e_48-Rel
PCLI 4.04.20
UEFI_Driver 0x05290000
  SCGCQ00477036 - UEFI driver issue with platforms when user having 2TB or 4TB VD
  SCGCQ00484087 - platfrom has UEFI hang when SATA is connected
  SCGCQ00492562 - Disable Debug print in UEFI Driver
  SCGCQ00492563 - Block IO tests from SCT IHV test suite failed
  SCGCQ00484115 - ATA PT: Follow UEFI Spec on interpreting In and Out Transfer Length that upper layer sends
Hii 1.38.00
  SCGCQ00492564 - Obtain the Physical Slot number from the PCI Bridge to which the Controller is connected.
BIOS 3.29.00
  SCGCQ00455597 - Memory allocation: Allocate only two 64k
FCODE 4.14.05.00

rshui · 发表于 2014-2-21 14:11

想入个阵列卡做raid 0+1或raid5 8盘*2T
请问什么卡合适呢

per1-q1222 · 发表于 2014-2-24 11:44

rshui 发表于 2014-2-21 14:11
想入个阵列卡做raid 0+1或raid5 8盘*2T
请问什么卡合适呢

4K盤???

明禅 · 发表于 2014-2-24 19:17

9260-8i能刷不？怎么变成英特公司发布出来的

per1-q1222 · 发表于 2014-2-24 21:40

本帖最后由 per1-q1222 于 2014-2-25 10:15 编辑

明禅发表于 2014-2-24 19:17
9260-8i能刷不？怎么变成英特公司发布出来的

f/w是由LSI處理...
IP是LSI的..

rshui · 发表于 2014-2-25 09:59

per1-q1222 发表于 2014-2-24 11:44
4K盤???

就普通的sata硬盘 3.5寸的普通家用型

per1-q1222 · 发表于 2014-2-25 10:15

rshui 发表于 2014-2-25 09:59
就普通的sata硬盘 3.5寸的普通家用型

說明一下規劃用麼甚麼盤?..
因為家用型很多是4K盤..

rshui · 发表于 2014-2-25 10:53

per1-q1222 发表于 2014-2-25 10:15
說明一下規劃用麼甚麼盤?..
因為家用型很多是4K盤..

ST2000DM001
预计上这款

per1-q1222 · 发表于 2014-2-25 11:02

rshui 发表于 2014-2-25 10:53
ST2000DM001
预计上这款

9260-8i+iBBU08即可...

rshui · 发表于 2014-2-25 11:07

per1-q1222 发表于 2014-2-25 11:02
9260-8i+iBBU08即可...

谢谢请问可有靠谱的渠道购买么

per1-q1222 · 发表于 2014-2-25 12:45

rshui 发表于 2014-2-25 11:07
谢谢请问可有靠谱的渠道购买么

住TW..
無法提供這方面資訊..

rshui · 发表于 2014-2-25 12:52

per1-q1222 发表于 2014-2-25 12:45
住TW..
無法提供這方面資訊..[sweatingbullets>

哎现在taobao上的lsi 9260和ibm的那个好像啊怕买假的 9261可以么

帐号		自动登录	找回密码
密码			注册

New LSI LSISAS2108 RoC MR firmware v12.​14.​0-​0185...

相关帖子

New LSI LSISAS2108 RoC MR firmware v12.14.0-0185...