操作步骤及注意事项：
由于我E文比较差，留下原文说明
Basic instructions:
1) Create the FreeDOS bootable floppy or CD-ROM.
2) Use a standard desktop PC with an integrated SATA controller, or
a common SATA add-in controller like a Promise SATA150-TX2.
3) Disconnect all PATA or SATA devices from the system, except the
device needing the firmware update.
4) Boot the system using the update floppy or CD.
5) At the (Seagate boot) A:> run the flash.bat file
***WARNING************************************************************
** DO NOT POWER DOWN the system or the drive during this upgrade
process. If power is lost during a firmware upgrade, the drive will
be destroyed.
** WAIT until all drive LED activity has ceased before powering off
the drive. Your system should come back to the message "Cycle power
to continue..." after the software finishes uploading the firmware.
** DO NOT use this software for any other purpose than the specific
firmware upgrade. Improper use of this tool can quickly destroy the
drive.
**********************************************************************
重点注意的是，建议系统只留启动光驱和准备升级的硬盘。
更新成功后直接关电源重新开机「Cycle power to continue」
，不要使用热重启「DON'T USE CTRL-ALT-DEL」
在刷固件的过程中保证机器不要断电。