LSI LSISAS2108 IMR f/w v12.12.0-0085發佈(from IBM)

per1-q1222

Download:
http://www-947.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5082167
請不要誤解..- Dimmer Switch function has been disabled by default.
這段意思, 這是永久關閉DS3的支持...
這個f/w不支援CC2.0Pro和CVPM..

Version 12.12.0-0085 - Critical-------------------
Enhancements:
- Prevent non IBM firmware from being flashing on IBM ServeRAID branded
   controllers.
- Enabled iBBU08 battery modes.
- ibbu battery will no longer be marked as bad when very high capacity is
   detected.
- Dimmer Switch function has been disabled by default.

Fixes:
- Fixed a issue where a NMI error will occur.
- Fixed issue where enabling security causes the configuration to be missing,
   and a configured FDE array to be seen as foreign on reboot.
- Removed BBU mode select from Web BIOS for all controllers.
- Fixed issue where pulling VD 0 from a R60 and rebooting would cause two
   foreign configurations.
- Fixed issue where WebBIOS gives unclear message when enabling FDE on an
   existing Disk Group.
- Fixed issue where iBBU07 batteries display 65K capacity and are marked SOH
   bad.
- Fixed issue where iBBU Absolute Charge is displayed differently
- Fixed issue where the logical Unit ID (VPD page 0x83) changed after
   foreign import.
- Fixed issue where the LDBBM entries are incorrect after foreign import.
- Fixed issue where the controller does not work with pci set to nomsi in
   kdump kernel.
- Fixed issue where the LED behavior is incorrect, wrong drive will blink
   activity.
- Fixed issue where the controller cannot sustain at least 950 MBps
   performance with Cache Flush setting one sec.
- Fixed issue where the set properties command fails
- Fixed issue where the iBBU07 battery reported remaining capacity is much
   too high (64751 mAh) after a learn cycle.
- Fixed issue where extended retries of write verify commands cause a driver
   timeout.
- Fixed issue where the configuration becomes foreign after  the firmware
   fails multiple attempts to access raid key during boot.
- Fixed firmware issue where a replacement drive is not seen if the
   replacement is added during power cycle.
- Fixed a issue where an alert should be sent when one phy connector
   between the SAS controller and SAS expander is degraded.
- Enabled puncturing for SATA drives.
- Enabled copy back on SMART.
- Fixed an intermittent RAID key failure during power-on.
- Fixed firmware issue where firmware would cause the controller to
   (sles11sp1/rhel6) reset when ‘lspci –vvx’ command is executed.
- Change for iBBU-08 to support firmware Mode5 WB capacity from 960mAh to
   674mAh for low power DDR-2
- Fixed a problem where the iBBU battery will not charge while the server
   continually resets causing the iBBU battery to over-charge.