. [/ Y# q1 I1 p: e) XActually, if you want to be technical, immediately to the right of the battery you will see an empty set of three solder pads marked "CLR CMOS" where a 3-pin header (for jumper) could be installed to allow for quickly clearning the CMOS. Right now the only way to do this is to either short those two points for a few seconds or to remove the battery.作者: squallmm 时间: 2006-11-2 20:59
其他人还有什么意见吗 楼上的兄弟谢了 不过304版已经把CLR CMOS的跳线取消了 只留下空焊位 不知道用2B铅笔连管不管用作者: somersby 时间: 2006-11-2 21:58
引文里说的就是短接焊点就可以了,只是跳线座没有安装,线路应该是在的作者: sunjiu 时间: 2006-11-2 22:13
移除电池,再用镊子的尖头短接3Pin的点几秒钟作者: davidmax 时间: 2006-11-2 22:49
找不到的 5 x7 d( `7 s. f% R0 L7 m因为被替代了 9 _- I; F/ X2 b"Intel Desktop Board 975XBX with an EFI SPI socket instead of a BIOS chip. "作者: caifeng333 时间: 2006-11-2 23:11
拔掉电源,移除电池,短接电池座30秒以上,OK作者: yu3130 时间: 2006-11-3 00:46
你是什么问题啊?我来指给你看看,哈哈~~8 F' }& Z% a8 O! `
$ |# A( P& H U3 @( _"The BIOS is stored in the Serial Peripheral Interface (SPI) Flash device and can be updated using a disk-based program.". `5 d7 t# d7 s* z3 L2 j9 |
% C/ y& F3 P2 ?* W就像楼上各位说的,它的Bios集成在ICH7里面,没有专门的可见的Bios芯片。 , ]3 Q: N: p5 M \# {7 e, v2 Q9 @ z, T @; y% ~7 n5 x6 g
304的默认的Bios应该是BX97510J.86A.0618,在10.25已经出了1441的新Bios。至于清COMS,你说跳线座都空焊了,那你贴的图的电池右面是什么?7楼的图倒是没看见,如果真省了,那只能拔电池短接试试了:p " ] \) ^4 I) [0 Z1 d8 b* j5 s