|
|
帮楼主贴个参数图吧...
The AUDIO 2 DJ connects to your computer via the USB 2.0 cable. The two 1/4 inch output channels can either be used to route stereo signals to an external mixer, or as a master out and headphone monitor for using the internal mixer of your DJ or performance software. The included cables make hooking up to any system a breeze- all you need is your AUDIO 2 DJ and laptop.
Amazing sound quality is guaranteed with super high-end Cirrus Logic? AD/DA converters. Ultra low-latency drivers, hi-gain output levels (providing up to 9.7 dBu on both channels), and the ultra-wide frequency response affirm the AUDIO 2 DJ's professional credentials. The uncompromising sound quality and clarity will reveal every detail of your music.
Professional USB 2.0 audio interface with ultra-high 24-bit/96kHz Cirrus Logic? converters
2 stereo 1/4" Line/Headphone level outputs
Manual volume controls for each stereo channel
Hi-gain outputs based on RC4580 Headphones OP AMP for punchy, loud level as also featured on the AUDIO 4 DJ and AUDIO 8 DJ interfaces
2 output LEDs (one LED for each stereo channel) for instant visual monitoring of connection status
USB 2.0 bus powered
Ultra-low latency ASIO?, Core Audio?, Direct Sound?, WASAPI? drivers
Compatible with software platforms VST?, Audio Units?, Stand-alone, RTAS?
2 phone-jack (1/4") to RCA adapter cables (cable length 1 m) and 1 shielded USB cable (approx. 1,5 m) are included in the product box
Audio 2 DJ System Requirements
Windows? XP (SP2, 32 Bit) or Windows Vista? (SP1, 32/64 Bit) or Windows? 7 (32/64 Bit), Pentium? IV or Athlon 1.4 GHz (SSE1), 1 GB RAM
Mac OS? X 10.5 or Mac OS? X 10.6 (32 Bit), Intel? Core? Duo 1.66 GHz, 1 GB RAM
Monitor with 1024 x 768 screen resolution, USB 2.0, DVD drive
Dimensions
3.5"(90 mm) x 2.3" (58 mm) x 0.9"(24 mm)
Weight: 3.2oz (90 grams)
Supported Drivers
ASIO?, Core Audio?, DirectSound?
Power
Power Supply Via USB 2.0 interface, 5V 500mA bus power. No additional power supply or battery is needed.
Audio 2 DJ Specifications
Audio Outputs (D/A)
Channels 2
Sample Rate 44.1, 48, 88.2, 96 kHz
Resolution 24-bit
Converter Cirrus Logic
Line Outputs
Output Impedance 100 Ohms Unbalanced, 200 Ohms Balanced
Maximum Output Level +9,6 dBu
SNR (weighted) 100 dBu (A-weighted)
THD+N 0,007%
Frequency Response +/- 1 dBu 10 Hz-40 kHz
Headphone Output
Load Impedance 8 Ohms - 600 Ohms
Maximum Output Level (100 Ohm load) 9,3 dBu, 4.26 V rms, 100 mW @ 100 Ohms
SNR (weighted) 95 dBu (A-weighted)
THD+N (100 Ohms) 0,012%
Frequency Response +/- 1 dBu 10 Hz-40 kHz
Video
|
|
IP卡
狗仔卡
发表于 2011-11-27 17:52
QQ好友和群
收藏
分享
好贴
烂贴
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡
楼主