本帖最后由 原装正品 于 2011-12-19 15:32 编辑
实物图片,价格:750 联系旺旺:鹤山刘也
Key Components
- Creative X-Fi CA20K audio processor
- One AKM AK-5394 super high performance 96kHz 24-bit ADC for analog input
- Four AKM AK-4396 96kHz 24-bit advanced multi-bit DAC for analog output
- 64Mbytes of memory for audio processing
- High fidelity audio OPAMPs for analog input and output (TI OPA2134)
- Front L/R output OPAMP is replaceable by end-user (National LM4562NA)
- Dual mode S/PDIF receiver and transmitter
Audio Performance (Rated Output @ 5Vrms, Typical Value)
- Signal-to-Noise Ratio (20kHz Low-pass filter, A-Weighted)
- Stereo Output : 120dB (part spec)
- Front and Rear Channels : 120dB (part spec)
- Center : 120dB (part spec)
- Subwoofer and Side Channels : 120dB (part spec)
- Total Harmonic Distortion + Noise at 1kHz (-3dBFS, A-weighted) : 0.001% - part spec
- Frequency Response (+/-0.01dB, 24-bit/44.1kHz input ) : 20khz (part spec)
- Frequency Response (+/-0.01dB, 24-bit/96kHz input ) : 43.5 khz (part spec)
- 16-bit to 24-bit recording sampling rates: 32, 44.1, 48 and 96kHz
- Maximum number of 3D Voices: 128
IO Connectors
- One 3.5mm MIC input connector in rear panel
- One 3.5mm line input connector in rear panel
- One 4-pin AUX connector on board
- Four 3.5mm 8 channel line output connectors in rear panel (FL/FR/C/SW/RL/RR/RSL/RSR)
- One S/PDIF combo input connector in rear panel for receiving either coaxial or optical digital
- One S/PDIF combo output connector in rear panel for transmitting either coaxial or optical digital
- One 10-1pin front panel connector on board for MIC input and headphone: more
- One 40-pin digital extension header on board to support AD-Link and other digital functionality
Swappable OPAMPs
- All Auzen soundcards support swappable OPAMP sockets for OPAMP upgrades.
S/W and drivers
|