|
|
本帖最后由 深蓝色海水 于 2010-10-6 18:33 编辑
回复 40# liukingdoms
在网上找到这么一张图和这么一段解释：
==========================================================
Maximum: 1.213 V — the editor displays the maximum possible value
-0.125 V — voltage value stepping
Limit: 1.1505 V — select an appropriate maximum possible voltage value form the drop-down list.
Next, move to the main parameters.
There are four groups of voltages — Settings 0-3. Firs value in the group sets the minimum possible voltage value, the second one — maximum possible voltage value. In this case, the minimum voltage need for card to operate well is 0.825 V. If you set the value lower than 0.825 V, then editors safety features won’t allow you to use it. now lets visualize the meaning of each parameter:
![]()
| Performance level | Function | Corresponds to voltage group | | P3 | GPU voltage value in Idle mode | Setting 0 | | P7 | GPU voltage value when decoding a video (PureVideo) | Setting 1 | | P12 | GPU voltage value when under a slight load (3D Low) | Setting 3 | | P15 | GPU voltage value when under significant load (3D) | Setting 3 |
Setting 2 groups is responsible for the original GPU voltage values (can’t be edited).
==========================================================
按照这段资料的解释，setting2最好是不要去动他的，P12和P15分别指3D Low和3D High，超频时只需修改setting3的电压值，直接把P12和P15的电压指向setting3就可以了
原文地址：http://hw-lab.com/nibitor-edit-fermi-voltage.html，可能需要爬墙 |
|
IP卡
狗仔卡
发表于 2010-10-6 00:21
显身卡
楼主