新一代的超频专用主板~~Inte新l的975扳子--XBX2在官网上出先了!!(增加改进的地方)

vongarnet

http://support.intel.com/design/ ... 2_documentation.htm
0 |; Z+ m# l- g3 l* z; u
[ 本帖最后由 vongarnet 于 2006-10-29 16:42 编辑 ]

CHENWEIHUA1980

看图片的话，做工的确很棒。

zaarath

xbx2是Intel对于超频破天荒第一次不在遮遮掩掩的产品，'overclocking'头一次出现在Intel的官网上。
& z5 e8 I3 S: ]  h4 Y6 K
口水哗哗的流啊，真想把我的xbx升级到xbx2.:p

+ y3 g; `) Q9 s' Q: \" P. h' F2 i0 Q忍住，忍住，不能继续烧钱了。:mad:

vongarnet

1.14 Onboard Power Button
# u  m; `* m6 }8 m* z! N" }9 K- m% KCAUTION
Electrostatic discharge (ESD) can damage components. The onboard power button
should be used only at an ESD workstation using an antistatic wrist strap and a
" d0 {8 a" l5 z& |5 y4 _0 s, o) aconductive foam pad. If such a station is not available, some ESD protection can be
: j' a( ?0 s' t/ O3 cprovided by wearing an antistatic wrist strap and attaching it to a metal part of the
3 W) n6 x* A2 M; P9 [: P. lcomputer chassis.
2 n) {1 B8 N7 u9 Z, y- cThe board provides a power button that can be used to turn the computer on or off.
4 H" V; C/ a  Z- U0 wThis button is intended for use at integration facilities to remove standby power before
making changes to the system configuration, or for testing purposes.
The power button on the front panel is recommended for all other instances of turning
" t! R$ |: @* d3 ?2 Y/ K0 cthe computer on or off. To turn the computer off using the onboard power button,
keep the button pressed down for three seconds.

1.15 Onboard LEDs
6 E# b$ E3 U4 f+ eIn addition to the standby power indicator, the board contains two LEDs that indicate
the following:
! Y. E- w9 O- t4 {- i7 m• The CPU LED indicates an elevated temperature on the processor that could effect
performance
' m" ?* K4 c6 m; C• The VR LED indicates an elevated temperature in the processor voltage regulator
7 p7 p1 F- z$ Tcircuit that could effect performance
6 V8 _- o" g* j; B: d5 Y7 T; ~Figure 16 shows the locations of the LEDs.