|
|
本帖最后由 per1-q1222 于 2012-5-12 07:53 编辑
==download==
http://www.lsi.com/downloads/Public/Host%20Bus%20Adapters/Host%20Bus%20Adapters%20Common%20Files/SAS_SATA_6G_P13.5/9211_8i_Package_P13.5_IR_IT_Firmware_BIOS_for_MSDOS_Windows.zip
BIOS updates:
Phase13 GCA Release Version 7.25.00.00 - SAS2BIOS_Phase13.0 (SCGCQ00252241)
Change Summary
Defects=0, Enhancements=0 (Version Change Only)
Phase13 Beta Release Version 7.24.05.00 - SAS2BIOS_Phase13.0 (SCGCQ00243841)
Change Summary ( Defects=2)
SCGCQ00223563 (CSET) - Bad drive which never finished spin-up made initialization appear to fail.
SCGCQ00242645 (CSET) - "Adapter Disabled" after downgrading FW while in Linux and reboot.
Phase13 Alpha Release Version 7.24.04.00 - SAS2BIOS_Phase13.0 (SCGCQ00235627)
Change Summary ( Defects=4 Enhancements=2)
SCGCQ00231683 (DFCT) - After installation of OS, booting into the OS fails and the system automatically gets into reboot cycles.
SCGCQ00231684 (DFCT) - BIOS CU displaying "Advanced Device Properties settings not found" message while entering into the Advanced Device Properties screen.
SCGCQ00235378 (CSET) - Pushing 'Print Screen' key while inside the CU causes an Illegal Opcode exception
SCGCQ00235381 (CSET) - The verify operation on a drive which has bad block is overwritting the screen and verify operation completes immediately.
SCGCQ00197069 (ENHREQ) - BIOS CU implement 4K sector drive filtering for IR volume creation
SCGCQ00210182 (ENHREQ) - Enhance legacy BIOS to fully support EDD 4.0 requirements.
Firmware updates:
Phase13.5 GCA Release Version 13.00.57.00 - SAS2FW_Phase13.5 (SCGCQ00259557)
Phase13.5 GCA Release Version 13.00.57.00 - SAS2FW_Phase13.5 (SCGCQ00259557)
Defects=0, Enhancements=0 (Version Change Only)
Phase13.5 Beta Release Version 13.00.56.00 - SAS2FW_Phase13.5 (SCGCQ00257378)
Change Summary ( Defects=6)
SCGCQ00227395 (DFCT) - iopDiagSnapshotTransferData has the wrong data type
SCGCQ00237373 (DFCT) - PL: SMP Passthrough of Discover List may time out
SCGCQ00254497 (DFCT) - SATL:Read capacity 16 lowest aligned high byte calculation is incorrect
SCGCQ00250564 (CSET) - (IOP-Only) Diagnostic code generates pointers to firmware areas incorrectly
SCGCQ00251832 (CSET) - Out of sync Phy cycling leads to an invalid expander details linked list and subsequent Discovery errors
SCGCQ00254244 (CSET) - Readcap 16 returns invalid data for 4K volumes
Phase13.5 Beta Release Version 13.00.55.00 - SAS2FW_Phase13.5 (SCGCQ00253881)
Change Summary ( Defects=3 Enhancements=1)
SCGCQ00247500 (DFCT) - OEM specific events may not be logged on cold-boot in Linux
SCGCQ00250546 (DFCT) - OEM specific drive carrier NVRAM is read on BIOS locate and delocate requests
SCGCQ00252172 (DFCT) - (IOP-only) Extend Thunderbolt C.1 PCIe3 fix to increase the likelihood of 8HGZ
SCGCQ00250531 (ENHREQ) - Add check to ensure only updating current-generation carriers
Change Summary ( Defects=6 Enhancements=2)
SCGCQ00231362 (DFCT) - Invalid topology change event sent by controller firmware when a device is removed
SCGCQ00245482 (DFCT) - Windows & Linux report box 2 in the failure message on 25+2 sff expander bp,should be box 1.
SCGCQ00245940 (DFCT) - Fault 0x2651 on a Message Unit Reset (MUR) after MPI2 Diagnostic BufferPost
SCGCQ00246057 (DFCT) - Ph13 IR: 0x8109:IFAULT_IR_NON_ZERO_IO_COUNT ?seen while removing R0 member drive during Host IO?
SCGCQ00250984 (DFCT) - 5861 fault on link drop during IO
SCGCQ00250991 (CSET) - Quick remove and attach of SAS Cables Drops Expanders from Topology
SCGCQ00250291 (ENHREQ) - Update OEM specific Drive Carrier Firmware to support newer hardware versions
Phase13.5 Alpha Release Version 13.00.53.00 - SAS2FW_Phase13.5 (SCGCQ00249673)
Change Summary ( Defects=10 Enhancements=1)
SCGCQ00237498 (DFCT) - Fault 0x265D Issue
SCGCQ00246683 (CSET) - Saving a host diagnostic trace buffer from the console does not work
SCGCQ00245892 (DFCT) - IOC state transition and Interrupt bit cleaning issue by MUR Issue
SCGCQ00245985 (DFCT) - pl: SATL: LowestAligned in READCAP_16 is wrong when LBA alignment == 0
SCGCQ00247203 (DFCT) - Thunderbolt D1: WHQL: PCI Class Code Incorrect
SCGCQ00247662 (DFCT) - Hostboot on SAS2308 May Fail
SCGCQ00248535 (DFCT) - Unexpected link reset on Write Current of SAS IO Unit Page 1
SCGCQ00246887 (CSET) - Some host trace buffers don't decode properly
SCGCQ00247242 (CSET) - IR performance using 512e (advanced format) drives is low
SCGCQ00247524 (CSET) - Unexpected delay or IR volume errors after drive or cable pull
SCGCQ00196617 (ENHREQ) - HP G8: FW does not send command to number enclosures
Phase13.5 Alpha Release Version 13.00.52.00 - SAS2FW_Phase13.5 (SCGCQ00246280)
Change Summary ( Defects=11 Enhancements=1)
SCGCQ00220978 (DFCT) - IR: PI: MDC runs on a SSD Volume created on a PI-enabled controller when roamed/activated after clean shutdown
SCGCQ00230606 (DFCT) - Fix handling of SATA drives which don't respond after being reset
SCGCQ00238905 (DFCT) - Fault 4300 observed during reset all Expander phys with IOs
SCGCQ00240457 (DFCT) - Mixing of PI type 2 formatted drives and non-PI drives results in error creating RAID volume
SCGCQ00240830 (DFCT) - IR firmware causes fault 0x501 when SEND DIAGNOSTIC command is issued to a volume.
SCGCQ00242753 (DFCT) - PL: Devices not reported as not responding after an SMP Open Failure in some cases.
SCGCQ00242855 (DFCT) - Reassign Block command fails with check condition 5/1A/00
SCGCQ00243257 (DFCT) - A PI Hot Spare is allowed to failover to a non-PI volume with PI Mixing Disabled
SCGCQ00243939 (DFCT) - Host IO uses PI on volume where BGI is pending
SCGCQ00245732 (DFCT) - ATA Error to SCSI Sense Translation Cleanup
SCGCQ00245832 (DFCT) - Gen 2 : Build failing for the latest tipcode.
SCGCQ00246035 (ENHREQ) - Set Back Channel Adaptation (BCA) to increase margin on receiver during Gen3 PCIE training.
Phase13.5 Alpha Release Version 13.00.52.00 - SAS2FW_Phase13.5 (SCGCQ00246280)
Total Enhancements Implemented (1) (SCGCQ00246035) Enhancement 1/1
HEADLINE: Set Back Channel Adaptation (BCA) to increase margin on receiver during Gen3 PCIE training.
NEW FUNCTIONALITY: The new setting allows BCA algorithm to increase margin on receiver
Phase13.5 Pre-Alpha Release Version 13.00.51.00 - SAS2FW_Phase13.5 (SCGCQ00245476)
Change Summary ( Enhancements=2)
SCGCQ00234888 (ENHREQ) - OEM specific changes for HDD firmware download
SCGCQ00242868 (ENHREQ) - NVDATA allows BIOS to show only 24 HDDs in a 25sff+2sff system
Phase13.5 Pre-Alpha Release Version 13.00.50.00 - SAS2FW_Phase13.5 (SCGCQ00242801)
Change Summary ( Defects=9 Enhancements=3)
SCGCQ00231519 (DFCT) - SATL: improved handling of CHECK POWER MODE response
SCGCQ00231793 (DFCT) - PL: Incorrect number of bytes displayed in "pl exp" UART command
SCGCQ00237555 (DFCT) - Fault 0x8111 seen while Activating a Degraded Raid 10 Volume
SCGCQ00238153 (DFCT) - (IOP-Only) Work-around for PCIe Errors on Thunderbolt D.0
SCGCQ00238503 (DFCT) - Embedded strings in host trace are corrupted
SCGCQ00238676 (DFCT) - 1901 fault after certain OEM specific drive failure logging errors
SCGCQ00239725 (DFCT) - (IOP-Only) Workaround for Thunderbolt C.1 at PCIe 3 and x4 Width
SCGCQ00242018 (CSET) - Internal Task Management events aren't blocked for IR
SCGCQ00242022 (CSET) - IR was failing drives and marking the volume degraded or broken when under device missing delay
SCGCQ00225796 (ENHREQ) - Add D1 Chip Recognition
SCGCQ00240314 (ENHREQ) - Modify customer specific sensor location information
SCGCQ00240584 (ENHREQ) - (IOP-Only) Enable C.1 PCIe 3.0 Work-around From SCGCQ00239725
|
|
IP卡
狗仔卡
发表于 2012-5-12 07:52
QQ好友和群
收藏
分享
好贴
烂贴
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡
楼主