Q6600温度比6000+高不少呀

pjtomtai

原帖由 jaguard 于 2008-1-12 01:20 发表


你认真看我的话，我说的是在CPU这样体积的芯片内，各部件不足以造成测温的区别，倒是很多主板测温有问题

你桨糊很会捣,我不相信CPU DIE的热成像图你没有看见过.

jaguard

原帖由 pjtomtai 于 2008-1-12 02:04 发表


你桨糊很会捣,我不相信CPU DIE的热成像图你没有看见过.

那你直接告诉我，CPU内部各部位的温差能有多少度？:shifty:你看热成像，一锅开水都有温差

itany

原帖由 jaguard 于 2008-1-12 06:58 发表

那你直接告诉我，CPU内部各部位的温差能有多少度？:shifty:你看热成像，一锅开水都有温差

开水当然可以有温差，不然电站的锅炉设计的不好怎么会爆炸呢？

看看Intel官方是怎么说的：

In the previous Pentium® M processor, a single analog thermal diode was used to measure die temperature. Thermal diode cannot be located at the hottest spot of the die and therefore some offset was applied to keep the CPU within specifications. For these systems it was sufficient, since the die had a single hot spot. In the Intel Core Duo processor, there are several hot spots that change position as a function of the combined workload of both cores. Figure 8 shows the differences between the use of the traditional analog sensor and the use of the new digital sensors.

Figure 8: Analog vs. digital sensors in Intel Core Duo processors
click image for larger view
  

As we can see the use of multiple sensing points provides high accuracy and close proximity to the hot spot at any time. An analog thermal diode is still available on the Intel Core Duo processor. The use of a digital thermometer allows tighter thermal control functions, allowing higher performance in the same form factor. The improved capability also allows us to achieve better ergonomic systems that do not get too hot, can operate more quietly, and are more reliable. Unlike diode-based thermal management algorithms that require some temperature guard band (or activating the self throttle mechanism as a safety-net), the digital thermometer is tested and calibrated against specifications. Full functionality and reliability of the processor are guaranteed, as long as the reported temperature is equal to or below the maximum specified temperature. Any inaccuracy or offset are programmed into the device and already accounted for.

[ 本帖最后由 itany 于 2008-1-12 15:22 编辑 ]

jaguard

原帖由 itany 于 2008-1-12 15:06 发表


开水当然可以有温差，不然电站的锅炉设计的不好怎么会爆炸呢？

我服了你，一立方水，用30W加热肯定有温差，可用30W加热1立方厘米水呢？

chengjd520

原帖由 lasty 于 2008-1-11 13:36 发表
现在这天气Q66待机24度左右吧，南海风扇基本不转

我的才7,8度

itany

原帖由 jaguard 于 2008-1-12 15:22 发表

我服了你，一立方水，用30W加热肯定有温差，可用30W加热1立方厘米水呢？

那也有温差，温度的梯度取决于你怎么分布热源、物体本身的导热系数和比热（液体更加复杂一些），和尺寸无关
另外，请你看看这个文献，之后再发言：http://documents.irevues.inist.fr/bitstream/2042/6579/1/TMI23.pdf

AMD采用鸵鸟政策，消费者自己不能采用鸵鸟政策吧，尤其是个别人还不懂装懂